Waterway Spa Hot Tub Pump Wet End 2" X 2" 48 Frame Barb 4 HP Executive Video

Description

To see our How To videos about this pump got to YouTube and search for "
How To Determine Which Wet End to Order Waterway Hot Tub Pump Executive Series The Spa Guy
" or "
Spa Hot Tub Waterway Executive Pump Seal Impeller & Bearing Replacement How To The Spa Guy
"
You are buying a
4 HP 48 Frame Waterway Executive 2" X 2" Wet End
/ Pump complete with
Bleeder Barb & Silicon
, Screws, Volute, Impeller, Seal, Face and the Wear Ring.
This Wet End would fit a motor that shows 14 Amps on the motor label on high speed.. Example 14.0/4.8...
The Barb and Silicon is used in place of a plug for wet ends that have bleeders on them.
If your wet end does not have a bleeder then we offer wet ends without bleeders in our eBay Store.
Watch the Videos to learn about how to pick the correct wet end as well as how to repair your wet end and motor bearings too.
The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3 5/8" between or 5 3/16" in a X Pattern and the 56 Frame will be 4 1/8" Between or 5 3/4" in a X Pattern. .
Note: Note: Note:
There are some cases where a 12 Amp motor has a 4HP impeller so if your motor has a 12.0 Amp Motor you need to check for the HP cast into the center of the impeller or loo at the wear ring.. If the wear ring says 1, 2 or 3 then you mostly likely have a 3HP impeller if it says 4 & 5 you most likely have a 4HP impeller...
Shipping in The United States is Free. I Ship International Through the Global Shipping Program Only!!
Look on the label of the motor for the two amperages if you have a 2 speed pump, if its a single speed look for a single amperage. It will look something like this: 10.0/3.5  The 10.0 is the high amperage in this example.  8.0 = 1 HP 10.0 = 2 HP 12.0 = 3 HP 14.0 = 4 HP 16.0 = 5 HP NOTE: Your pump or motor may say a different Horse Power than what you see here, DO NOT go by what is listed on the motor, go by the amperage on the label.  NOTE for the NOTE: TRUST ME ON THIS, everybody lies about their Horse Power. But the amperage does not lie. Most people are told they have 5 HP pumps, if you do the math two 5 HP pumps at 16 amps is 32 amps. Plus a 5.5 KW heater is 21 amps. That means with both pumps running and the heater on it will draw 53 AMPS. I bet your HOT TUB is on a 50 AMP breaker. Therefore contrary to what you have been told you DO NOT have a 5 or 6 or 7 Hp pump.
310-1910,wet end,wetend,waterway,pump,pumps,315-1220,315 1220,3151220,motor,